Connecting to the hardware

 
Connecting the PC to the hardware via Ethernet allows the uploading of the system design, revision of the firmware operating system for connected devices and real time control of parameters and routings within the DSP Soundweb London devices.

It should be ensured that the Soundweb London devices have been installed in their equipment racks, and that the connections between them are the same as in your system design.

PC connection via Ethernet

The PC must have an Ethernet connection (100BT, RJ45 connection) to be connected to the network on which the London Devices reside. Connect using either a CAT-5 crossover cable, or straight through cable if going via a network switch. The "˜Ethernet" RJ45 rear mounted control port is used for this purpose (not the CobraNet ports).

 
See the tutorial Connecting to a Soundweb London network for further information.